Eurotherm 2000 Series Controllers
This Video Tutorial will show you how to change the Thermocouple Type on a Eurotherm 2200 Series Controller.
Presently the controller is setup as Type J Thermocouple with a range of 0-600°C.
We are going to change it to a Type K Thermocouple with a range of 0-1372°C
First we begin by putting the controller into the Configuration level.
- Please note when putting the controller into the configuration level all outputs are shut off from the process. Before doing this, make sure it is safe to do.
We will be using the four buttons across the bottom of the controller.
The left most button is called the PAGE Button.
The next button to the right is the SCROLL Button.
The next button to the right is the DOWN Button.
The final button to the right is the UP Button.
- First we begin by pressing the Page Button repeatedly until you see the ACCS List.
- Press the Scroll Key Once and you will see Code Pass, with the UP Button change the value Pass to 1.
- Now press the Scroll Key Once and you will see GOTO OPER.
- With the Up or Down Buttons change the value OPER to CONF.
- Now press the Scroll Key once and you will see Code 0, with the UP Button change the value 0 to 2.
- Now press the Page Button and the display will change to INST CONF.
- Now press the Page Button once and the display will change to IP Conf.
- Now press the Scroll button once and the display will read inPT J.TC
- Now press the Up Button to change the displayed value from J.TC to K.TC
- Now press the Scroll Button once and the display should read RNG.L is 0°C, if it is not 0°C then with the Up or Down buttons change the value to 0°C.
- Now press the Scroll Button once and the display should read RNG.H is 600°C.
- Now we want to change the RNG.H value from 600°C to 1372°C. Press the UP Button until the value reads 1372°C.
- Now press the Page Button repeatedly until the display reads Exit NO.
- Press the Up Button to change the value NO to YES.
At this time the controller will reboot. You have successfully changed the Thermocouple type from Type J to Type K and the Range from 0-600°C to 0-1372°C.
Last item to change is raising the Operating Setpoint High limit from 600°C to 1372°C.
- Press the Page Button repeatedly until the display reads SP List. If you do not see the SP List then this list is Hidden from the Operator. If so, you must put the controller into the FULL Level to see the SP List.
- To put the controller in the FULL Level, press the Page Button repeatedly until you see the ACCS List.
- Press the Scroll Key Once and the display will read Code Pass, with the UP Button change the Pass to 1.
- Now press the Scroll Key Once and you see GOTO OPER.
- With the Up or Down Buttons change the OPER to FULL.
- Now press the Scroll Key Once.
- Press the Page Button repeatedly until the display reads SP List.
- Now press the Scroll Key until the display reads SP1.H is 600°C.
- Now press the UP Button to change the value 600°C to 1372°C.
- Now press both the Page and Scroll buttons together and this will bring you back to the Home Display.
Now you have successfully completed this change.
